Installation; Appropriate Installation Location; Installing The Plastic Wedges; Electrical Connection - Beko GN1306220VZDX Manual De Usuario

Ocultar thumbs Ver también para GN1306220VZDX:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3

Installation

Refer to the nearest Authorised Service Agent for
installation of the product. To make the product
ready for use, make sure that the electricity
installation is appropriate before calling the
Authorised Service Agent. If not, call a qualified
electrician to have any necessary arrangements
carried out.
C
Preparation of the location and electrical
installation at the place of installation is
under customer's responsibility.
B
Product must not be plugged in during
installation. Otherwise, there is the risk of
death or serious injury!
WARNING:
B
connections of the product must be carried
out by the Authorised Service Agent.
Manufacturer shall not be held liable for
damages that may arise from procedures
carried out by unauthorised persons.
A
WARNING:
check if the product has any defects on
it. If so, do not have it installed. Damaged
products cause risks for your safety.
C
Make sure that the power cable is not
pinched or crushed while pushing the
product into its place after installation or
cleaning procedures.

3.1 Appropriate installation location

WARNING:
A
the product will be placed is too small for
the product to pass, then the product's
doors must be removed and the product
must be turned aside to pass it through.
• Choose a place at where you would use the
product comfortably.
• Install the product at least 30 cm away from
heat sources such as hobs, ovens, heater
cores and stoves and at least 5 cm away from
electrical ovens. Product must not be subjected
to direct sun light and kept in humid places after
installation.
• Appropriate air ventilation must be provided
around your product in order to achieve an
efficient operation. If the product is to be placed
in a recess in the wall, pay attention to leave at
least 5 cm distance with the ceiling and side
walls.
Installation and electrical
Prior to installation, visually
If the door of the room where
• Do not place the product on the materials such
as rugs or carpets.
• Place the product on an even floor surface to
prevent jolts.
• Do not install the product in places where the
temperature falls below 10ºC /50°F.
C
If two coolers are to be installed side
by side, there should be at least 4 cm
distance between them.

3.2 Installing the plastic wedges

Plastic wedges are used to create the distance
for the air circulation between the product and
the rear wall. Insert the 2 plastic wedges onto the
rear ventilation cover as illustrated in the figure.
To install the wedges, remove the screws on the
product and use the screws given in the same
pouch with the wedges.

3.3 Electrical connection

Connect the product to a grounded outlet
protected by a fuse complying with the values in
the rating plate. Our company shall not be liable
for any damages that will arise when the product
is used without grounding in accordance with the
local regulations.
• Electrical connection must comply with national
regulations.
• Power cable plug must be within easy reach
after installation.
• The voltage and allowed fuse or breaker
protection are specified in the Rating Plate
which is affixed to interior of the product. If
the current value of the fuse or breaker in the
house does not comply with the value in the
rating plate, have a qualified electrician install a
suitable fuse.
• The specified voltage must be equal to your
mains voltage.
• Do not make connections via extension cables
or multi-plugs.
8 /38 EN
Refrigerator / User Manual

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido