Installation; Right Place For Installation; Attaching The Plastic Wedges; Adjusting The Stands - Beko RCNE560E60ZGWHN Manual De Instrucciones

Installation

3

3.1. Right place for installation

Contact the Authorized Service for the
product's installation. To ready the product
for installation, see the information in the
user guide and make sure the electric and
water utilities are as required. If not, call an
electrician and plumber to arrange the utilities
as necessary.
WARNING:
B
assumes no responsibility for any
damage caused by the work carried
out by unauthorized persons.
WARNING:
B
cable must be unplugged during
installation. Failure to do so may result
in death or serious injuries!
WARNING:
narrow for the product to pass,
A
remove the door and turn the product
sideways; if this does not work,
contact the authorized service.
• Place the product on a flat surface to avoid
vibration.
• Place the product at least 30 cm away from
the heater, stove and similar sources of heat
and at least 5 cm away from electric ovens.
• Do not expose the product to direct sunlight
or keep in damp environments.
• The product requires adequate air
circulation to function efficiently.
• If the product will be placed in an alcove,
remember to leave at least 5 cm distance
between the product and the ceiling and the
walls.
• Do not install the product in environments
with temperatures below -5°C.

3.2. Attaching the plastic wedges

Use the plastic wedges in the provided with
the product to provide sufficient space for air
circulation between the product and the wall.
1. To attach the wedges, remove the screws on
the product and use the screws provided with the
wedges.
2. Attach 2 plastic wedges on the ventilation cover
as shown in the figure.
The manufacturer
The product's power
If the door span is too

3.3. Adjusting the stands

If the product is not in balanced position,
adjust the front adjustable stands by
rotating right or left.

3.4. Power connection

A
WARNING:
multi sockets in power connection.
WARNING:
B
must be replaced by Authorized
Service.
When placing two coolers in adjacent
C
position, leave at least 4 cm distance
between the two units.
• Our firm will not assume responsibility
for any damages due to usage without
earthing and power connection in
compliance with national regulations.
• The power cable plug must be easily
accessible after installation.
• Do not use multi-group plug with or
without extension cable between the wall
socket and the refrigerator.
• Your product requires adequate air
circulation to function efficiently. If
the product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and the
ceiling, rear wall and the side walls.
• If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product and
the ceiling, rear wall and the side walls.
12 /35 EN
Do not use extension or
Damaged power cable
Refrigerator / User Guide