Sauder 416408 Manual Del Usuario página 14

Step 10 Step
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten a DOOR (G) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (25K) to the DOOR (G). Use a SILVER 7/8"
å
MACHINE SCREW (42S).
Peel a FELT DISC from the FELT DISC CARD (1M) and
å
stick it on the DOORS where they come in contact with
the UPRIGHT (C).
Repeat this step for the other DOOR (G).
å
See the next step for DOOR adjustments.
å
1M
25K
1M
Page 14
G B
42S
SILVER 7/8" MACHINE SCREW
(2 used for the KNOBS)
Stop
Mounting
screw
C
416408
Pro Tip: Lift with your
legs. And, you know,
your arms.
Hinge
www.sauder.com/services