Section 3 Operation; Operation And Use Questions; Before Starting Engine; Prepare Generator For Use - Togo POWER GG3600 Manual Del Propietário

Section 3 Operation

Operation and Use Questions

Call BALDR INTERNATIONAL LLC customer service at
+1 (855)801-0798 with questions or concerns about
equipment operation and maintenance.

Before Starting Engine

1. Verify engine oil level is correct.
2. Verify fuel level is correct.
3. Verify unit is secure on level ground, with proper
clearance and is in a well ventilated area.

Prepare Generator for Use

DANGER
Asphyxiation. Running engines produce carbon
monoxide, a colorless, odorless, poisonous gas.
Carbon monoxide, if not avoided, will result in
death or serious injury.
DANGER
Asphyxiation. The exhaust system must be
properly maintained. Do not alter or modify the
exhaust system as to render it unsafe or make it
noncompliant with local codes and/or standards.
Failure to do so will result in death or serious
injury.
DANGER
Risk of fire. Do not use generator without spark
arrestor installed. Failure to do so could result
in death or serious injury.
DANGER
Asphyxiation. Always use a battery operated
carbon monoxide alarm indoors and installed
according to the manufacturer's instructions.
Failure to do so could result in death or serious
injury.
WARNING
Risk of Fire. Hot surfaces could ignite
combustibles, resulting in fire. Fire could result
in death or serious injury.
WARNING
Hot Surfaces. When operating machine, do not
touch hot surfaces. Keep machine away from
combustibles during use. Hot surfaces could
result in severe burns or fire.
CAUTION
Equipment and property damage. Disconnect electrical
loads prior to starting or stopping unit. Failure to do so
could result in equipment and property damage.
Owner's Manual for Petrol Generator
Grounding the Generator When
Used as a Portable
This generator has an equipment ground that connects
the generator frame components to the ground
terminals on the AC output receptacles (see NEC
250.34 (A) for explanation). This allows the generator
to be used as a portable without grounding the frame of
the generator as specified in NEC 250.34.
Special Requirements
There may be Federal or State Occupational Safety and
Health Administration (OSHA) regulations, local codes,
or ordinances that apply to the intended use of the
generator. Please consult a qualified electrician,
electrical inspector, or the local agency having
jurisdiction:
• In some areas, generators are required to be
registered with local utility companies.
• If the generator is used at a construction site, there
may be additional regulations which must be observed.
Connecting the Generator to a
Building Electrical System
When connecting directly to a building's electrical
system, it is recommended that a manual transfer
switch is used. Connections for a portable generator to
a building's electrical system must be made by a
qualified electrician and in strict compliance with all
national and local electrical codes and laws.
Figure 8 - Grounding the Generator

Know Generator Limits

Overloading a generator can result in damage to the
generator and connected electrical devices. Observe the
following to prevent overload:
• Add up the total wattage of all electrical
devices to be connected at one time. This
total should NOT be greater than the generator's
wattage capacity.
• The rated wattage of lights can be taken from light
bulbs. The rated wattage of tools,appliances, and
motors can be found on a data label or decal affixed to
the device.
9