Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4 Operation
Set Clock
is used to set the circulator's
Set Time/Date
hr : min : sec
(
year - month - day
(
Format Date
is only applied to the date sent
DD/MM/YYYY
out the serial interface
MM/DD/YYYY
. The date displayed is fixed at
year - month - day
Set Time/Date
Format Date
Menu
Remote Sensor
is used to enable the optional remote temperature sensor feature, see Section 3.
Remote Sensor
1. With optional
Auto Restart
is used to enable the auto restart feature. When enabled, the immersion circulator auto-
matically restarts after a power failure or power interruption condition is restored. If a ramp was run-
ning when power failed, the ramp program resumes where it left off. Note Consider any possible risks
before enabling this mode of operation.
Auto Restart
1. With
Energy Saving
is used to enable the energy savings mode. The Energy Saving mode is primarily
designed for applications running under a stable load. Enabling the mode saves energy by reducing the
circulator's heater power and cooling requirements. This can result in substantial energy savings over the
life of the circulator. The default setting is disable (enable for A45HC refrigerated circulators).
Energy Saving
1. With
4-46
) and date
).
or
.
highlighted, press
highlighted, press
highlighted, press
On/Off Timer
circulator's timer.
On/Off Timer
1. With
to display the on (
the enable box.
I: 2021-03-03
O: 2021-03-03
Enable
After setting the on and off times highlight
Enable
and press
to toggle between enable and disable.
to toggle between enable and disable.
to toggle between enable and disable.
is used to enable and set the
highlighted, press
I
O
) and off (
) time as well as
08:10:00
10:45:00
Menu
to activate the timer.
Thermo Scientific
Publicidad
Tabla de contenido
