To Lubricate The Wire (555Fxt); Troubleshooting; The Engine Does Not Start - Husqvarna 555FX Manual De Usuario

• In temperatures below -5°C/23°F, install the wear
guard with an air duct (D).
CAUTION:
than -5°C/23°F or 0°C/32°F, remove the

The engine does not start

Check
Stop switch.
Starter pawls.
Fuel tank.
Carburetor
30
At temperatures of more

Troubleshooting

Possible cause
The stop switch is in the stop posi-
tion.
The starter pawls cannot move free-
ly.
Incorrect fuel type.
Incorrect adjustment of the idle
speed
winter kit from the product. There is a risk of
engine damages.

To lubricate the wire (555FXT)

Note:
The wire is lubricated at the factory. Lubricate
the wire monthly.
1. Remove the protective cover.
2. Remove the cylinder cover to get access to the
rubber bellows on the wire.
3. Remove the plug on the grease nipple.
4. Use antifreeze spray with a 2 mm spray tube. Spray
in short intervals.
5. Examine the rubber bellows on the wire to make
sure that it does not expand.
6. Attach the cylinder cover and the protective cover.
Procedure
Let an approved servicing dealer re-
place the stop switch.
Remove the starter cover and clean
around the starter pawls. Refer to
clean the cooling system on page 25 .
Let an approved servicing dealer
help you.
Drain the fuel tank and fill with cor-
rect fuel.
Adjust the idle speed with the idle
speed screw T.
To
1346 - 004 - 03.06.2021