If the bristles are retracted inside the brush, turn the bristle
retraction knob in the direction of the arrow (1) to make the
bristles come out of the brush () (Fig. 1).
Take a lock of hair and wind it round the brush. Make sure you
wind the end of the lock in the required direction (Fig. 1).
-
Do not wind too much hair round the brush at a time.
-
The thinner the lock of hair, the tighter the curl.
-
Do not wind a lock of hair more than twice round the brush.
-
Make sure the lock of hair is in contact with the barrel of the brush.
Note: To give your hair optimum lift and volume, wind the hair at right angles
to the scalp.
5
Set the control slide to the preferred setting to switch on the
appliance. (Fig. 6)
6
Hold the brush in place as long as required (normally 8 to 10
seconds).
7
As soon as the hair feels dry, fix the curl with a cool airflow (blue
indication) for long-lasting results (Fig. 1).
8
Switch off the appliance. Turn the bristle retraction knob in the
direction of the arrow to retract the bristles. Then remove the
brush from your hair (Fig. 15).
Make sure you hold the brush away from the underlying hair when you
remove it to preserve underlying curls.
Let the curls cool down before you comb, brush or finger-comb
the hair into its final style.
styling with the straightening comb (HP8651 only)
Use the straightening comb to create a straight style.
1
Snap the straightening comb onto the appliance (Fig. 16).
Note: There are two ways to connect the straightening comb: with the lever
on the same side as the control slide or on the opposite side. However, as the
lever is rather long and partly covers the control slide, it is most convenient to
connect the straightening comb the other way round.
EnglisH
11