Transport; Pictogramas; Assembling Instruccions; Mounting The Blades - Sima CEL-30 Manual De Instrucciones Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1

2.1 TRANSPORT

For a safe transport of the machine, please follow the following instructions:
The Electrical Shear is fitted with holes on the working table to be lifted with cranes through chains or cables. The used
means of transport must be safe, taking into account the form of use, the nature of the load.
WARNING: Keep away f rom th e lif ted lo ad and be car eful o f it s sud den dis placement to avoid a ny possib le da nger
during t ransportation, moora ge, charging or di scharging. Therefore t he choice of t he correct of th e cable, c hain a nd
sling is fundamental.
The electrical shears are equipped with a ring B, Fig.2 for its lifting or transport. The CEL models have also a
transport handlebar A, Fig.2 to move it for short distances.
:
During the transport of the machine, the latter should never be rev ersed nor be p ut on either
IMPORTANT
side. The machine is only to rest on its four feet Fig. 2.

2.2 PICTOGRAMAS.

Pictograms included in the machine entail the following:
READ
MANUAL
USE SAFETY GLOVES

3. ASSEMBLING INSTRUCCIONS

The machine is delivered mounted and prepared to operation.

3.1 MOUNTING THE BLADES

If one of the blades gets blunt due to frequent use, replace it as follows:
1
CHANGING THE FIXED BLADE. Make sure the machine is u nplugged from el ectricity. Lift the safety
guard off the blades A, Fig.3 taking it out from its housing. Remove the protection B, Fig.3 fixed to the
left side of t he m achine t o have ac cess t o the screws of the b lades, r emove t he screws C, Fig.3 and
rotate the blade D, Fig.3 for a new set of cuttings or substitute it with a new blade if necessary.
CHANGING THE MOVEABLE BLADE. To do this, it is necessary to remove the connecting rod from its
2
housing E, Fig.3, and t hen p roceed as to the fo llowing: when t he machine is pu t on , sw itch it off by
pressing the s top but ton. W hile de f lywheel is making i ts last t urns, press the ped al to p ush the
connecting ro d from its ho using to hav e acc ess to scr ews f ixing t he blade s F, Fig.3. Immediately
thereafter, unplug the machine off the network to avoid accidents. If the connecting rod is no t out of its
housing, turn gently the flywheel from the inferior part of the safeguar d that covers the engin e until the
connecting rod is out of its housing, and then remove the screws off the bl ade for a new cutti ng face or
replace it with a new one if necessary. At the end, proceed to the inverse to restore the operation of the
machine.
The screws are to be tightened with a torque wrench as per the following:
3
CEL-30------ 25,07Nm.
CEL-35------ 84,24Nm.
CEL-45------ 135,13Nm.
INSTRUCTIONS
AUTEK MAQUINARIA 5392 7077
USE HELMET AND EYE AND EAR
DEFENDERS
USE SAFETY FOOTWEAR
AUTEK MAQUINARIA 5392 7077

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cel-35Cel-45

Tabla de contenido