Tabla de contenido
Publicidad
Enabling Camera Recording
Adding Camera to UltraConnect
Make sure the ZeroWire panel is on the same local area network as the camera(s).
1. From your iOS or Android device, open the UltraConnect app and log in to the site as
the installer.
2. Click More on the bottom of the screen, then Settings.
3. Select Cameras under the Settings Selector.
4. Click Scan for New Cameras. "Success!" message will pop-up after a few moments.
5. Make sure the MAC ID that is automatically populated in the MAC Address field
matches the MAC Address printed on the underside surface of the camera. If not,
change in the MAC Address to the one listed on the back of the camera.
6. Click Save.
Note:
The camera may take up to 3 minutes to finalize the association with ZeroWire and
display on the Cameras tab.
7. Congratulations! You have now added the camera to your ZeroWire system!
Manual de instalación de ZeroWire
MAC: C4:2F:90:31:C9:94
75
Publicidad
Tabla de contenido
