Technical Menu - AERMEC DMP Serie Manual Del Usuario

10.8. TECHNICAL MENU

This allows to modify the TECHNICAL
menu parameters listed below
To access the menu, enter the INFO
menu (see procedure described abo-
ve) and then hold the
down for 3 seconds.
Code
SP Water Set Point [°C]
COMFR Humidity Set Point
ECO Humidity Set Point
S3 Ch 3 B3 Probe type
1 = Coil Water
Temperature
(WS)
DIFFH Differential for Dehumi-
CAL T Terminal temperature
probe calibration [°C]
CPON Cycle CP 300" [s]
CPD Delay CP 30" [s]
DDT Time between Defrost
DT Defrost duration [min]
CAL H Terminal humidity probe
calibration [%rH]
FAND Delay FAN 10" [s]
SBY D Dehumidify Standby
22
To exit the TECHNICAL mode, press the
key.
To scroll use the
the parameters, press
+ . keys values using the
confirm the value using the key
Parameter Default
15
65
[rH%] Comfort
65
[rH%] Economy
0
10
dification [rH%]
0
24
30
30
[min]
5
0
30
85
and keys
, To modify
., change the
and
keys and and
..
Range
0..25 Set point for plant water temperature and for dehu-
10.. 1 00 Adjustment set point for Comfort humidity
10.. 1 00 Adjustment set point for Economy humidity
0.. 1
0..30 Differential for dehumidification
-5..+5 Calibration of the temperature probe present on the
24..60 It is expressed in tenths of seconds (240"..600")
10..60
5..50 Time between two defrosts
1.. 1 5
-10..+10 Calibration of the humidity probe present on the
5..60
10.. 1 00 Dehumidification set point in the VACANZA mode
N.B.: before pressing to modify the
value of a parameter, wait for the current
value of this parameter to be displayed
Notes
midification consent
0 = probe deactivated
terminal
Duration of the defrost
terminal