J5create JUA 310 Manual Del Usuario página 11

USB DISPLAY ADAPTER
6. After rebooting connect the external display device (monitor/
projector) to the VGA connector of USB Display Adapter and turn on
the display device.
7. Connect the USB 3.0 Display Adapter into an available USB port of a PC
or Notebook, After Inserting the USB 3.0 Display Adapter into an USB
port, the "Installing device driver software" message will pop up.
If the Driver software was installed successfully the following message
should appear:
If you're not going to install another USB 3.0 Display Adapter, restart your
PC. The functions of the USB 3.0 Display Adapter will be activated after
the computer restarted.
Multi USB 3.0 Display Adapter Installation
For installation of multiple USB 3.0 Display Adapters, during the "Install
Shield Wizard complete" step, select "No, I will restart my computer later."
and click Finish to continue next step below
11
USER MANUAL