Introduction; Dear Customer; Driving And Transport On Public Roads; Towing - Husqvarna R 120S Manual De Instrucciones

Dear customer!

Thank you for choosing a Husqvarna Rider. Husqvarna Riders are built to a unique design with a front-mounted cutting deck and
a patented articulated steering. Riders are designed for maximum efficiency even in small or confined areas. The closely grouped
controls and pedal-operated hydrostatic transmission also contribute to the performance of this machine.
This operator's manual is a valuable document. By following its instructions (on operation, service, maintenance, etc.) you will
significantly extend the life of the machine and even its second-hand value.
When you sell your Rider, make sure you pass on the operator's manual to the new owner.
The last chapter in the operator's manual consists of a Service Journal. Make sure that all service work and repairs are recorded.
A well-documented service history reduces the costs of seasonal maintenance and influences the second-hand value of the
machine. Bring the operator's manual with the Rider when bringing it to a workshop for service procedures.

Driving and transport on public roads

Check the relevant road traffic regulations before driving the machine on a public road. If transporting the machine on another
vehicle always use approved securing devices and make sure that the machine is securely held.

Towing

When your machine is equipped with a hydrostatic transmission you should only tow the machine over short distances and at a
low speed, otherwise there is a risk of damaging the transmission.
The power transmission must be disengaged when towing, see the instructions under the heading Release lever.

Use

This ride-on mower is designed to mow grass on open and level ground surfaces and sloped surfaces that do not exceed 10
degrees. In addition, there is a number of accessories recommended by the manufacturer that broadens the application area.
Please contact your dealer for more information about which accessories are available. The machine may only be used with the
equipment recommended by the manufacturer. All other types of use should be avoided. Compliance with and strict adherence to
the conditions of operation, service and repair as specified by the manufacturer also constitute essential elements of the intended
use.
This machine should be operated, serviced and repaired only by persons who are familiar with its particular characteristics and
who are acquainted with the relevant safety procedures.
Accident prevention Recommendations, all other generally recognized regulations on safety and occupational medicine, and all
road traffic regulations must be observed at all times.
Any arbitrary modifications carried out to this machine may relieve the manufacturer of liability for any resulting damage or injury.

Good service

Husqvarna products are sold all over the world and ensures that you, the customer, get the best support and service. For example,
before this machine was delivered it was inspected and adjusted by your dealer. See the certificate in the Service Journal in this
manual.
When you need spare parts or advice on service issues, warranty terms, etc., contact:
This Operator's Manual belongs to machine with
serial number:
On the machine's rating plate you will find the following information:
• The machines type designation.
• The manufacturer's type number.
• The machine's serial number.
State the type designation and serial number when ordering spare parts.

INTRODUCTION

Motor Transmission
– 3
English