Applying Detergent With Adjustable Nozzle; Pressure Washer Rinsing; Automatic Cool Down System (Thermal Relief) - Briggs & Stratton GENERAC 1950PSI Manual Del Propietário

Applying Detergent With Adjustable
Nozzle
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
CAUTION
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent, follow these steps:
1. Review adjustable nozzle use.
2. Prepare detergent solution as required by job.
3. Place filter end of chemical injection hose into detergent
container.
CAUTION
Keep the chemical injection tube from coming in contact
with the hot muffler.
• When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler.
4. Slide adjustable nozzle forward to low pressure mode.
Detergent cannot be applied with nozzle in high pressure
position.
5. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray gun
and pump; start engine.
6. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
7. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as needed to prevent
surface from drying. DO NOT allow detergent to dry on
(prevents streaking).
IMPORTANT: You must flush the chemical injection
system after each use by placing the filter into a bucket of
clean water, then run the pressure washer in low pressure
for 1-2 minutes.
Generac Portable Products 1950 PSI Pressure Washer

Pressure Washer Rinsing

For Rinsing:
1. Slide nozzle backward to high pressure, squeeze trigger
NOTE: You can also stop detergent from flowing by simply
removing chemical injection hose from bottle.
2. Keep spray gun a safe distance from surface.
• Keep spray nozzle between 8 to 24 inches away from cleaning
• Operate this unit on a stable surface.
• Be extremely careful if you must use the pressure washer from
• Firmly grasp spray gun with both hands when using high
3. Apply high pressure spray to a small area, then check
4. Start at top of area to be rinsed, working down with
Automatic Cool Down System
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°F.The system engages to cool the pump by
discharging the warm water onto the ground.
10
and wait for detergent to clear.
WARNING
High pressure spray could cause you to fall if
you are too close to the cleaning surface.
surface.
a ladder, scaffolding or any other relatively unstable location.
pressure spray to avoid injury if gun kicks back.
surface for damage. If no damage is found, it is okay to
continue cleaning.
same overlapping strokes as used for washing and
applying detergent.
(Thermal Relief)