CHIEF iC iCSPDA2 Instrucciones De Instalación página 13

Installation Instructions
3
4
2 M x4
7mm
3A
2
75 x 75mm, 100 x 100mm
2
100 x 200mm, 200 x 200mm
A F x2
2 H x4
1
3 H x2
A
(H, Q) x2
1
F x2
(H, Q) x2
3
L x2
INSTALL DISPLAY TO ARM ASSEMBLY
1. If display has a 75 x75mm or 100 x 100mm mounting
pattern, proceed to Step 3A ("Flush Mounting Holes") or
Step 3B ("Recessed Mounting Holes"), as applicable.
Otherwise, continue below.
2. Install screws (H) through brackets (F) and arm assembly
(A) into nuts (M).
3. Proceed to Step 3A ("Flush Mounting Holes") or Step 3B
("Recessed Mounting Holes"), as applicable.
Flush Mounting Holes
IMPORTANT!
This procedure only applicable when 4mm or
6mm diameter mounting holes are flush with back surface of
display.
H x2
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the combined weight of
all components attached to the iCSPDA2 does not exceed
40 lbs (18 kg).
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily and completely thread
into display mounting holes.
CAUTION:
Inadequate thread engagement in display may
cause display to fall! Back out screws ONLY as necessary to
allow installation to arm assembly.
1. Install two screws (H or Q, as applicable) into the upper
mounting holes on display. Thread screws completely into
display, then back out 3 complete turns.
NOTE:
100 x 100 and 200 x 200 mounting hole patterns
shown; 75 x 75mm and 100 x 200mm patterns similar.
2. Align display so that screws installed in previous step fit into
upper pair of teardrop mounting holes. Lower display firmly
into place.
NOTE:
Display will be hanging on upper two screws.
3. Install two remaining screws (H or Q, as applicable) through
lower pair of teardrop mounting holes.
• If installing screws (H) through brackets (F), then install
washers (L) under screw heads (H).
4. Tighten all four screws (H or Q, as applicable). Do not
overtighten!
A
iCSPDA2
13