Cub Cadet RT65 Serie Manual Del Operador página 5

2. Place the handle assembly in position
between the handle bracket. See Figure 2-3.
Handle Assembly
Hex Screws
Handle
Bracket
Flange
Lock Nuts
Figure 2-3
3. Line up the holes in the handle with the holes
in the bracket and secure it with hardware
previously removed.
Emergency Stop Control Installation (If Equipped)
Some models come equipped with an emergency
stop control switch. If equipped you will need to
complete installation of this safety feature prior to
operating the tiller.
WARNING! Use extreme caution when
reversing or pulling the machine towards
you. To avoid getting pinned against a
structure, ensure adequate distance before
reversing near a wall or fence. For machines
with powered reverse drive capability,
familiarize yourself with the operation of the
Emergency Stop Control. It provides a
means of stopping power to the tines and
wheel drive in an emergency situation.
1. To finish handle installation locate the
emergency stop control wire on the right side
of the unit behind the engine.
2. Route the wire up the handle shaft and secure
with cable ties just above the lower handle
adjust bracket and below the upper handle
adjust bracket. See Figure 2-4.
Figure 2-4
3. Route the wire over to the left side of the
handle and secure with a cable tie on the
lower part of the handle. See Figure 2-5.
NOTE: Leave a little extra slack in the emergency
stop control wire between the cable ties in steps
2 and 3 of this section to allow full range of
motion for the upper handle adjust.
Figure 2-5
4. Mount the emergency stop control ON/OFF
switch onto the left side of the handlebar with
the #10-32 : 1.50 hex bolt and 10-32 flange lock
nut. See 1 in Figure 2-6.
2
Figure 2-6
5. Secure the wire near the top of the handlebar with
a cable tie on the left handlebar. See 2 in Figure 2-6.
Clutch Cable
Attach the clutch cable to the handle as follows: (be
careful not to kink the cable)
1. Remove the threaded eyebolt and nut from
the cable end.
2. Route the clutch cable to the right side of the
handle mounting brackets and underneath
the handle.
3. Push the cable through the hole in the center
of the handle and snap into the plastic fitting.
See Figure 2-7.
4. Remove the machine screw, flange lock nut
and washer from the clutch control. See Figure
2-8.
Clutch Control
1
5. Fasten the threaded eyebolt onto the bail by
securing it from the top with the machine
screw, washer and flange lock nut.
6. Thread the eyebolt and nut removed earlier
into the internally threaded tube at the end
of the cable. Thread engagement should be
about 3⁄4". Tighten the nut against the tube at
the end of the cable. See Figure 2-8.
NOTE: Do not overtighten the clutch cable.
Too much tension may cause it to break. Be
certain to check the clutch cable adjustment
before operating the tiller. See Clutch Cable
under Adjustments in this section for cable
adjustment instructions.
S
ection
Plastic Fitting
Internally
Threaded Tube
Figure 2-7
Machine Screw
Flat Washer
Flange
Threaded
Lock
Eyebolt
Nut
Nut
Internally
Threaded
Tube
Figure 2-8
2 — A & S -U
SSembly et p
5