Preliminary Recommendations - WEG SCA06 Guia De Instalacion

Expansion Module for Communication Profibus - ECO3

1.3 PRELIMINARY RECOMMENDATIONS

DANGER!
Only qualified personnel familiar with the SCA06 servo drive and associated equipment
should plan or implement the installation, start-up, operation and subsequent
maintenance of this equipment.
These personnel must follow all the safety instructions included in this guide and/or
defined by local regulations.
Failure to comply with these instructions may result in life threatening and/or equipment
damage.
NOTE!
For the purposes of this guide, qualified personnel are those trained to be able to:
1. Install, ground, energize and operate the product according to this guide and the
effective legal safety procedures.
2. Use protective equipment according to the established standards.
3. Give first aid services.
DANGER!
Always disconnect the general power supply before touching any electrical component
connected to the servo drive.
Many components may remain charged with high voltages and/or moving (fans), even
after the AC power supply input is disconnected or turned off.
Wait for at least ten minutes so as to guarantee the full discharge of the capacitors.
Always connect the frame of the equipment to the proper protection grounding (PE).
ATTENTION!
Electronic boards have components sensitive to electrostatic discharges. Do not
touch the components or connectors directly. If necessary, first touch the grounded
metallic frame or use proper grounding strap.
6 SCA06