Safety Information; Safety Warnings; Preliminary Recommendations; General Information - WEG CFW100 - IOADR Guía De Instalación, Configuración Y Operación

1 SAFETY INFORMATION

1.1 SAFETY WARNINGS

NOTE!
Only use the I/O expansion module and
„
infrared remote control (IOADR) on WEG
CFW100 series inverters with firmware
from version V2.10 up (see P023).
It is recommended to read the CFW100
„
user manual before installing or operating
this accessory.
This guide contains important information
„
for the correct understanding and proper
operation of this module.

1.2 PRELIMINARY RECOMMENDATIONS

ATTENTION!
Always disconnect the general power
„
supply before connecting or disconnecting
the accessories of the CFW100 frequency
inverter.
Wait for at least ten minutes for the full
„
discharge of the inverter.

2 GENERAL INFORMATION

This guide provides directions for the installation,
configuration and operation of the remote control and
I/O expansion module (CFW100-IOADR).

3 CONTENT OF THE PACKAGE

Upon receiving the product, check if the package
contains:
Accessory in anti-static package.
„
NTC Sensor with 1-meter cable.
„
Infrared (IR) remote control.
„
1.5-meter infrared receiver cable.
„
Infrared Remote Control and I/O
Expansion Module
CFW100 | 5