Sanus SOA-AVS1 Manual De Instrucciones página 9

3. Drill pilot holes using a 10 mm (3/8 in.) diameter drill bit.
IMPORTANT: Pilot holes must be drilled to a depth of 75 mm (3 in.). Never drill into the mortar between blocks.
4. Insert anchor (concrete)
CAUTION:
Be sure the anchors are seated flush with the concrete surface.
02
5. Install using lag bolt
the BOTTOM hole. Tighten lag bolt
CAUTION:
Improper use could reduce the holding power of the lag bolt and screw. DO NOT over-tighten the lag bolt and screw.
3
75 mm ( 3 in.)
06
in the TOP hole and a dry wall anchor
03
and washer (into anchor (concrete)
02 04
and screw
4
10 mm
(3/8 in.)
05
in the BOTTOM hole.
06
) in the TOP hole, and a wall screw
only until they are pulled firmly against the wall plate
06
05
06
STEP 1B
04
(into dry wall anchor
01
.
5
03
02
01
04
05
) in
9