Voice Language Setting; Applying Your Blood Pressure Cuff - MABIS Healthcare 04-595-001 Manual De Instrucciones

Voice Language Setting

To set the desired voice language:
1. When the unit is off, you can select the desired voice language by pressing and
holding the MEMORY button.
2. Now the screen will cycle through L0, L1 and L2 as shown in Fig. 1.
L0 - voice function is off
L1 - voice is in English
L2 - voice is in Spanish
The monitor will say the corresponding language with the displayed language code.
3. Once the desired language has been selected, release the MEMORY button.
4. After the desired language has been selected, you can adjust the volume by pressing
and holding down the MEMORY button until the bars on the side of the screen begin
to increase Fig. 2.
5. Continue to hold the MEMORY button down until the volume reaches the desired
level, then release the MEMORY button to set.
6. The unit will automatically turn off after the desired volume level has been set.
Fig. 1
Fig. 2
– 12 –

Applying Your Blood Pressure Cuff

Before applying your blood pressure cuff, be sure you have selected the appropriate cuff:
Small Adult Cuff fits arm circumference 8-5/8" - 11-3/4" (22-30 cm)
Adult Cuff fits arm circumference 11-3/4" - 16-1/2" (30-42 cm)
Large Adult Cuff fits arm circumference 16-1/2" - 18-7/8" (42-48 cm)
NOTE: If for any reason you are unable to or should not use your left arm, please modify
the following instructions and apply the cuff to your right arm.
Your physician can tell you which arm is best for you to use.
1. Remove any constrictive clothing or jewelry that may
interfere with the cuff placement.
2. Be seated with your feet flat on the floor.
3. Position the cuff on a solid surface with the tubing facing
UP and AWAY from you, Fig. 1. The metal bar on the cuff
should be to the left of the tubing.
4. Widen or open the cuff by pulling or rolling the
bottom of the cuff towards the right, Fig. 2.
This should open the cuff, creating a cylinder.
Do not extend the cuff beyond the metal bar.
5. Insert your arm into the cuff (cylinder).
Position the ( ) mark over the main artery
(on the inside of your arm), Fig. 3.
6. The bottom edge of the cuff should be
positioned approximately one inch ABOVE
the elbow joint, Fig. 4.
7. Reaching underneath your left arm with your
right hand, pull the end of the cuff towards
your body to tighten the cuff, Fig. 5. Wrap and
secure the cuff making sure that the ( ) mark
remains as shown, Fig. 3.
8. The cuff should fit comfortably, yet snugly around your arm.
You should be able to insert two fingers between your arm
and the cuff.
NOTE: The cuff size is suitable for use when the vertical "Index" mark is within the
horizontal "OK" range. A different sized cuff is needed if the "Index" mark is outside of the
"OK" range.
Fig. 1
Fig. 2
Fig. 3
1"
Fig. 4
Fig. 5
– 13 –