Bentel Security Wave WSB Instalación página 3

! ! ! ! ! Do not touch the PCB for at least 2
minutes after removing the power sup-
_ _
ply: 250 V_ _ _ may still be present across
the PCB circuitry of this device.
! ! ! ! ! This device is designed to work with
Nickel-Cadmium batteries. When dispos-
ing of used batteries, abide by the Local
laws in force.
General Features
Available with or without back-up battery, with
or without Strobe
2 selectable sound types
Tamper detection (tamper and snatch tamper)
Universal Wall mount bracket
General Description
The Wave HornStrobe is an Audible-Visual Alarm
signalling device for Security Systems.
It is available in four versions, as per the follow-
ing table.
Version Strobe
Wave/WSB
Wave/WB
Wave/WS
Wave/W
All versions have piezoelectric transducers for
audible signalling, whereas only the Wave/WSB
and Wave/WS versions are fitted with Strobes
for visual signalling.
The Wave/WSB and Wave/WB versions are fit-
ted with 7.2 V – 300 mA batteries (art. CB7203)
for back-up power during blackout.
All versions have tamper terminals that signal the
removal of the Lid and the snatch.
Back-up Battery
YES YES
no YES
YES no
no no
ENGLISH
Installation Guidelines
Carefully work through the following steps (see
Figure 1).
+ This HornStrobe is suitable for indoor use
only.
1. Remove the Logo Insert 5.
2. Remove the screw 4.
3. Pull the Lid 3 upwards and away from the
backplate.
4. Remove the Lens cover 2.
5. Using a screwdriver or similar tool, push down
on the locking tab 9 and push the Wall bracket
12 away from the Backplate 10.
6. Pull the connection wires through the cable
entry 13.
7. Using anchor screws, secure the Wall bracket
12 to the wall or to the outlet box.
+ Snatch Tamper functions ONLY when a
screw is properly fixed in the hole 14 (fi-
gure.1).
! ! ! ! ! Be careful to avoid conduits and plumb-
ing when drilling.
8. Pull the connection wires through the cable
entry 11.
9. Slide the Backplate 10 downwards onto the
Wall bracket 12 until it snaps closed.
10. Select the required sound type, as per the
instructions in the relevant section.
11. Complete the connections on the terminal
board 7, as per the instructions in the rel-
evant section.
12. Replace the Lens cover 2.
13. For Wave/WSB and Wave/WB only: locate
the battery 6, as per Figure 1, then connect it
to the input J5.
! ! ! ! ! For Wave/WSB and Wave/WB only: before
connecting the battery, ensure that: the Posi-
tive Voltage (13.8 V) is on terminal +B; the
Positive Voltage (13.8 V) is on terminal +N
or jumper J3 is connected; Ground is
present on –A.
14. Snap the top of the Lid 3 onto the Backplate
10, then push the bottom part onto the
backplate posts.
15. Replace the Closure screw 4.
16. Replace the Logo Insert 5.