Addressing / Control Via Pc - Beyerdynamic Opus 910 Manual Del Usuario

1.4.7 Name
• Turn the menu control
name.
• To enter a new name press the menu control. The first digit will start to flash. Turn the menu
control to select the desired letter, number or character.
• In order to confirm and to enter the second digit, press the menu control. Repeat these steps to
enter all desired characters, letters or numbers. You can enter a maximum of 6 digits, symbols or
letters.

1.4.8 Addressing / Control via PC

• Turn the menu control
channel is displayed.
• To ensure a smooth control via PC, the receiving channels have to be addressed differently before
using the software.
IMPORTANT:
Each channel must have its own address. If two or more channels have the same address, errors
will occur. If the receivers are operated without a PC, it does not matter if two or more receivers
have the same address.
• When the receiver is PC-controlled "ON" and a number are displayed. This number is the address
of the appropriate channel.
• When the receiver is operated without PC "OFF" and the address are displayed.
• If you want to adjust or change the address, press the menu control. The number will start to
flash. Turn the menu control to select the desired address. In order to confirm the selected address,
press the menu control.
to select "NAME". A stored name is displayed or you can enter a new
7
to select "REMO". The address and the status of the remotely controlled
7
51