Fan Assembly - Craftmade DE52CH4 Guia De Instalacion

4. Mounting Plate Installation. (cont.)
Secure mounting plate to outlet box using original
screws, spring washers and flat washers provided
with new or original outlet box.* Pull electrical
wiring from outlet box through center hole in the
mounting plate.
*Note: It is very important that you use the proper
hardware when installing the mounting plate as this
will support the fan.

5. Fan Assembly.

With the mounting plate secured to the outlet
box and able to support the fan, you are now
ready to hang your fan.
Grab the fan firmly with two hands.Lift motor
assembly to mounting plate. Use the obolong
hole in the plate at the top of motor assembly
and slide it over the "J" hook on the mounting
plate. This will allow motor assembly to hang out
of the way while wiring.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
Find a secure attachment point (wood ceiling
joist highly recommended) and secure safety
cable. It will be necessary to use a heavy duty
wood screw, washer and lock washer (not
supplied) with the safety cable loop. If
necessary, adjust the loop at the end of the
safety cable. The loop at the end of the safety
cable should just fit over the threads on the
wood screw. Extra cable slack can be left in
ceiling area.
mounting plate
flat washers
spring washers
outlet box screws
obolong hole
motor assembly
wood
ceiling
joist
safety cable
page 4
"J" hook
safety cable loop
wood screw
and washer