Operation; Pressure Washer Location - Craftsman 580.752710 Instrucciones De Uso

HOW TO USE YOUR CLEANING
SYSTEM
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.

Pressure Washer Location

Pressure Washer Clearance
WARNING
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• Keep at least 5 ft. (152 cm) clearance on all sides of
pressure washer including overhead.
Place pressure washer in a well ventilated area, which
will allow for removal of deadly exhaust gas. DO NOT
place pressure washer where exhaust gas could
accumulate and enter inside or be drawn into a
potentially occupied building. Ensure exhaust gas is
kept away from any windows, doors, ventilation
intakes or other openings that can allow exhaust gas
to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when
positioning pressure washer.
WARNING
Running engine gives off carbon monoxide,
an odorless, colorless, poison gas.
Breathing carbon monoxide can cause
nausea, fainting or death.
• Operate pressure washer ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
• DO NOT operate pressure washer inside any building or
enclosure, even if doors or windows are open.

OPERATION

To Start Your Cleaning System
To start your engine-powered cleaning system for the
first time, follow these instructions step-by-step. This
information also applies whenever you start the engine
after you have let the pressure washer sit idle for at
least a day.
1. Place pressure washer near an outside water
2. Check that high pressure hose is tightly connected
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure
DO NOT run the pump without the water supply
connected and turned on.
5. Squeeze trigger on gun to purge pump system of
6. Attach nozzle extension to spray gun. Tighten by
7. Choose ProjectPro™ nozzle you want to use, pull
8. Engage trigger lock to spray gun trigger.
Typical Pressure
Washer Shown
Exhaust Port
10
source capable of supplying water at a flow rate
greater than 3.3 gallons per minute and no less
than 20 PSI at pressure washer end of garden
hose.
to spray gun and pump. See "Assembling Your
Pressure Washer" for illustrations.
washer pump. Turn ON water.
CAUTION
• Damage to equipment will result from failure to follow
this instruction.
air and impurities.
hand.
back on collar of nozzle extension, insert nozzle
and release collar. Tug on nozzle to make sure it
is securely in place. See "How to Use
ProjectPro™ Nozzle System".
Trigger Lock