How Does My Landroid; Finding The Charging Base; Rain Sensors; Sensing The Boundary Wire - Worx Landroid M Manual Del Usuario

3.2 How Does My Landroid

Know Where To Go?
®
Your Landroid M is capable of doing things on its own. The
®
Landroid M knows when it needs to go to its Charging Base (4)
to charge, can sense when it is raining, can stop itself if it senses
a problem, and knows to stop, draw back, and then turn around
when it bumps into something blocking its path or other object.
®
The Landroid M will also automatically stop its Blade Disc(13) from
rotating if it is lifted off the ground to prevent an accident.
A. Finding the charging base
When your Landroid
follow the Boundary Wire (21) in an counter-clockwise direction back
to its Charging Base. Landroid
grass near the boundary wire once a week. If you want to mow the
grass near the boundary wire at other times, open the panel cover,
press the home button and close the panel cover. Landroid
stop mowing, locate the boundary wire and mow the grass near the
boundary wire while it locates the charging station . We suggest you
use this function when the battery power is more than 75%. You can
check the battery power in the display.
B. Rain sensors
®
The Landroid M is fitted with a Rain Sensor (9) that will detect
rain drops and tell the Landroid
Boundary Wire back to its Charging Base (See Fig. B )
®
The Landroid M is programmable to have a delay start function
(0 – 180 mins) when it rains. When the rain sensors are wet, the
®
Landroid M stops cutting and returns to its docking station. Only
when the rain sensors become dry will the Landroid
delay start countdown or return to mowing immediately. See the
10
Programming and Troubleshooting Guide for more details.
C. Sensing the boundary wire
®
The Landroid M always obeys the border set by the Boundary Wire
and uses two sensors at its front to sense when it is getting close (See
Fig. C). Before changing direction, the Landroid
Boundary Wire up to 8 inches*.
*This is the recommended distance. Use the provided distance
gauge to ensure proper installation.
D. Starting and stopping while mowing (See Fig. D, E)
If you would like to command the Landroid
then simply press the STOP button (8) on top of the mower. To start
mowing open the Control Panel Cover, press the ON/OFF key and
input the PIN code, then press start key and close the panel cover.
®
If the Landroid M senses that something is wrong, it will display a
fault message on the Display (17), and will turn itself off if it does not
receive any input from the user within 20min (for information on fault
messages refer to the Programming and Troubleshooting Guide).
To resume:
Action 1: STOP –Auto Shutdown after 20 mins
• Open the Control Panel Cover
• Press the ON/OFF Key (19) to ON
• Press 0 key to correct the problem
• Press START button again and Close the Control Panel Cover
• Now the Landroid
Action 2: STOP– Without Auto Shutdown
• Open the Control Panel Cover
• Press 0 key to correct the problem
• Press START button again and Close the Control Panel Cover
• Now the Landroid
Lawn Mowing Robot
®
M needs to recharge, it will stop mowing and
®
M is pre-programmed to mow the
®
M to stop mowing and follow the
®
M will overrun the
®
M to stop mowing,
®
M will begin to mow!
®
M will begin to mow!
®
M
B
®
M will
®
M begin the
C
D D
E
EN