Keep It Sharp; Rotate And Flip The Blades; Replace The Blades; Keep It Clean - Worx Landroid M Manual Del Usuario

6.1 Keep It Sharp

WARNING: Before cleaning, adjusting, or replacing
the Blades, turn your Landroid
protective gloves.
WARNING: When fitting new blades, make sure
you replace ALL the blades. Always use new
screws when fitting blades . This is important to ensure
blade retention. Failure to use new screws could cause
serious injury.
®
The Landroid M does not cut grass like other mowers. Its
Cutting Blades (14) are razor sharp on all 4 edges and spin in both
directions for maximum cutting capacity (See Fig. K). Each blade of
®
your Landroid M has 4 cutting edges. Depending on the frequency
®
the Landroid M mows your lawn, the cutting blades will need
to be flipped/rotated periodically for a new cutting edge. If your
®
Landroid M is programmed to mow the lawn every day then
the cutting blades will need to be rotated monthly for the best
mowing results. Each cutting blade will last up to 4 months when
it is programmed to mow every day. When the cutting blades are
dull and worn out, they should be replaced with the spare blades
provided with your Landroid
your nearest WORX retailer or www.worx.com.
A. Rotate and flip the blades
®
Your Landroid M carries the Blades that are all screwed onto
the Blade Disc(13). The blades allow the Landroid
and need care and attention. Every once in a while, you should
simultaneously rotate and flip all blades for a perfect cut. When
rotating and flipping the blades, make sure all the blades are
adjusted at the same time or else it could make the
Blade Disc off balance. If your Landroid
schedule (daily) then the blades should last 4 months if they are
rotated and flipped every month. Always check to see if the blades
are chipped or damaged and replace them if they are.
B. Replace the blades (See Fig. K)
After some time, usually every season, your Landroid
will need to be replaced. Your Landroid
while using Blades of different age and quality. So when replacing
the Blades, make sure to replace all of them at the same time. You
can replace them with one of the three spare Blade kits and extra
Blade screws supplied with your Landroid
Before attempting to replace your Landroid
power off and put on protective gloves. Then follow these steps:
1. Gently flip the Landroid
2. Remove the battery cover and remove the battery.
3. Take the screws off the Blades with a screwdriver.
4. Firmly screw on the new Blades.
5. Refit the battery and the battery cover.
IMPORTANT: After screwing the Blade to the Blade Disc, make sure the Blade is able to spin freely.

6.2 Keep It Clean

WARNING: Before cleaning turn your Landroid
the Blade Disc (13) and do not use running water. (See Fig. L, M)
A. Cleaning the body
®
Your Landroid M will live a much happier and longer life if it is cleaned regularly. Although, as your Landroid
Lawn Mowing Robot
® M OFF and put on
®
M. Spare blades are also available at
®
M do its job
®
M mows on a normal
®
M's Blades
®
M does not like mowing
®
M.
®
M's Blades, turn the
®
M over.
1
3
J
K
L
®
M OFF . Put on protective gloves before cleaning
2
4
13
®
M is an
EN