Publicidad
Idiomas disponibles
Idiomas disponibles
Volume setting/Melody selection
Press the "Volume"/"melody forward/backward" button until you hear the
required volume/melody.
You can change the volume at any time and this is independent of the
corresponding transmitter. The last selected volume is automatically saved.
You can still replay different bell tones by pressing "Melody forward/backward".
This does not effect the saved bell tone when coding between transmitter and
receiver.
Installation
Choose a suitable location for the chime and motion detector. Check the selected
location for wiring before drilling any holes.
Tip: Test the desired function before ultimately installing the device at the place
of installation you chose.
Place the motion detector at a suitable location. The non-slip coating is included
in the packaging and provides for a secure grip on the floor or use the assembly
fixture with the enclosed screws. The recommended installation height is
2 - 2.2m, to cover a maximum detection zone.
Note:
• The detection zone depends on the selected location. Wall-mounted or
ceiling installation should be favoured.
• Avoid undesired sources of heat, cold and movement, e.g. fan heaters, direct
sunlight, refrigerators or fans, in the detection zone, to prevent false alarms.
• Avoid the motion detector lens from being shielded, so as not to limit the
detection zone, e.g. by plants or furniture.
• Select the location in a manner, which allows the detection of movement based
on the crossing of several detection zones. The detection of movement is less
precise in the direction of the motion detector than it is crosswise to it.
• Avoid installation opposite windows. In this case, air flow or motion in front of
the window can trigger false alarms.
17
Troubleshooting
Error
Error correction
description
The chime
•
Check the batteries of the receiver (chime) and the
transmitter (bell push, motion detector, window
does not
sound
contact). Change the batteries if necessary.
•
Check whether the distance between the receiver
(chime) and transmitter (bell push, motion detector,
window contact) is too far. If necessary, reduce the
distance, to get back within the range.
•
Check whether the receiver (chime) is coded with
the transmitter (bell push, motion detector, window
contact). If necessary, code the receiver and transmitter
as described above.
•
Check the volume setting of the receiver (chime).
Increase the volume if necessary.
Range is low
•
Check the mounting surface and the surroundings.
Metal surfaces can reduce the range. Avoid installation
on or near metal.
•
Structural conditions (e.g. concrete walls or ceilings)
can have an effect on the range.
•
Other wireless products in the vicinity can have an
effect on the range. Change the location of the receiver
(chime) and/or transmitter (bell push, motion detector,
window contact) or the other wireless product.
•
Check the batteries of the receiver (chime) and
transmitter (bell push, motion detector, window
contact). Change the batteries if necessary.
18
Publicidad
