Turning On The Equipment; Delivery System; Electric Panel; Base And Progressive Pedal Controls (Operation) - Olsen SPRINT Manual De Operaciones

5.2 - Turning On the Equipment

1º - Turn On the On/Off switch (3), its LED indicator will light;
2º - Activate the "Seat Up" command on the chair base (section 5.3)
until the seat reaches its maximum height limit;
3º - Close the pressure valve (2);
4º - Remove the water tank (1) and make sure it filled with water. If
necessary, fill it with drinkable water up to the limit indicated in
the tank and reattach it again. If you wish to place prophylactic
products (low concentration);
5º - Open the pressure valve (2) and check if the water tank (1) is
well attached and free of leaks.
6º - Before starting the use of equipment, verify the operation of all instruments and
commands available and perform the cleaning and sterilization of the instruments
(chapter 7 of the User Manual Dental Line - Cleaning and Disinfection)

5.2.1 - Delivery System

1 - Water Tank
2 - Pressure Valve

5.2.2 - Electric Panel

3 - On/Off Switch with LED Indicator
4 - Fuse Holder

5.3 - Base and Progressive Pedal Controls (Operation)

1 - Zero Position
2 - Work Position
3 - Backrest Up ( )
4 - Seat Down ( )
5 - Backrest Down ( )
6 - Seat Up ( )
7 - Operating Light Control
8 - Bowl Flush Water Control
9 - Vórtice Saliva Ejector
10 - Progressive/Activation Pedal
To activate each command simply
press the respective button or in the case
of the movements of the chair, press the
joystick at the points indicated in the side
image (3 to 6).
In case of the equipment has the
high-power Vórtice Saliva Ejector, the spittoon bowl flush command (8) will be placed on the water unit, and the
command for Vórtice ejector (9) will be available on the chair base.
To activate the handpieces: press the progressive/activation pedal (10).
10