Storage And Maintenance - Protemp PT-18-PCH-A Manual Del Usuario

Always disconnect the LP cylinder from the regu-
lator assembly and remove the LP cylinder from
the heater before putting the heater into storage.
If, for any reason, the heater is to be stored in-
doors, the heater MUST be disconnected from the
LP cylinder, and the cylinder stored outdoors in
a well-ventilated area, out of the reach of chil-
dren, and in accordance with the Standard for
Storage and Handling of Liquefied Gasses, ANSI/
NFPA 58 - latest edition. The plastic valve plug or
valve cover supplied with the LP cylinder must be
reinstalled on the valve to protect the fitting from
damage.
NOTE: Repair of this heater should be done by a
qualified service person.
It is recommended that you save all of the pack-
aging materials that came with your heater, and
re-package the heater using these materials for
safe storage.
Debris, dust and dirt inside of the heater body can
affect the performance of your heater. This de-
bris can impair the heaters ability to draw air for
ventilation and combustion. Spiderwebs can also
appear during periods of inactivity.
DANGER
CAUTION
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE CONNECTED TO
®
STORAGE / MAINTENANCE
Never store an LP cylinder inside of a building or near any other gas or oil
burning appliances.
Always be sure that the heater has been allowed to cool for at least 30
minutes before attempting to store, service, or perform maintenance.
A FUEL SOURCE
Be sure to inspect the heater before each use to
look for any such obstructions. Be sure to keep
the air passage-ways, burner and combustion ar-
eas clean. Wipe with a damp cloth or use a vac-
uum cleaner to clean these areas. It is suggested
that you perform a thorough cleaning at least once
every 30 days of operation. You may need to clean
the heater more often if conditions are naturally
dirty.
Clean the ceramic plaques using compressed air
below 30 PSI to prevent damage to plaques.
A yellow tip of the pilot flame indicates that the
burner area may be in need of cleaning.
10
Cabinet Heater User's Manual