Specifications - Protemp PT-18-PCH-A Manual Del Usuario

WARNING
– ALWAYS install the heater so that it is not directly
exposed to water spray, rain, dripping water, or
wind.
– Use heater in accordance with all local codes
and with CSA 5.90 U.S. (5th Ed.) Infrared
Patio Heater.
– This heater is shipped from the factory for use
with propane (LP) gas only. Do not convert
to any other gas. Installation must conform
to local codes, or in their absence, with the
standard for the Storage and Handling of
Liquefied Petroleum Gases ANSI/NFPA 58
and the Natural Gas and Propane Installation
Code CSA B149.1.
– Gas supply connections should be checked by
using a 50/50 soap and water solution. Never
use a flame to check for gas leaks.
WARNING
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE CONNECTED TO
®
SAFETY INFORMATION (CONT.)
For use with propane
(LP) gas only.
RISK OF FIRE! ALWAYS LOCATE HEATER ON A STABLE AND LEVEL
SURFACE!

SPECIFICATIONS

Model #
BTU
Fuel Consumption (lb./hr)
Heat Settings
Maximum Operating Hours
Required Cylinder Lbs.
Fuel Type
Heating Area (Ft. )
2
Specifications subject to change without notice.
A FUEL SOURCE
– Use only the regulator and hose assembly
provided with this heater. Inspect the
regulator/hose assembly prior to each use of
the heater. If there is excessive abrasion or
wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list, prior
to using the heater.
– This heater is not for use on finished floors.
Minimum and Maximum Inlet Pressure
Model
Min.
Max.
WARNING
material and contact with hot surfaces both
during use and while in storage.
PT-18-PCH-A
6,600 / 12,000 / 18,000
0.31 / 0.56 / 0.83
3
65 / 36 / 24
20
Propane
165 / 300 / 450
4
PT-18-PCH-A
5 PSI
Bottle Pressure
The hose assembly
shall be pro tected
from traffic, building
Cabinet Heater User's Manual