Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30

Troubleshooting

EN
PROBLEM
POSSIBLE CAUSE
No electrical
contact between
power tool and
battery.
Power tool
Battery has low
does not start
charge (beep once
after switch-
per 10 sec).
on.
Battery too hot
/ too cold (LED
indicate HI or LO &
beep continuously).
10
cramer.eu
SOLUTION
Remove adapter, check
contacts and refit adapter.
Charge the battery.
Allow battery to cool down to
temperatures of about 10-40°C
(50-104°F). Allow battery to
warm up slowly.
PROBLEM
POSSIBLE CAUSE
Malfunction in
battery (LED
will indicates
Malfunction code
such as E0,E1,
E2,E3,E4,E5,E6).
Electromagnetic
problem or
malfunction in
machine.
SOLUTION
Disconnect battery from power
tool, take it off your back,
observe battery and contact
your CRAMER servicing dealer
immediately.
If the battery emits fumes,
heats up, smells, makes
noises or shows signs of
deformation, disconnect it
from the power tool, take
it off your back, put it down
and immediately move a safe
distance away. Keep children
and animals away from the
work area. Keep battery away
from combustible materials.
Take the adapter out of the
power tool and refit it. Switch
on the power tool – if it still
doesn't work, the power tool
has a malfunction and must
be checked by a CRAMER
servicing dealer.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

82v86029035862903686

Tabla de contenido