Cramer 82VH860 Manual Del Usuario página 13

PROBLEM POSSIBLE CAUSE
Moisture in power
tool and/or battery.
Battery or
machine's
electronics are too
hot.
Electrical or
electromagnetic
malfunction.
Power tool
shuts down
during
operation.
Malfunction in
battery (LED
will indicates
Malfunction
code such as
E0,E1,E2,E3,
E4,E5,E6).
SOLUTION
Allow power tool battery to dry.
Take the adapter out of the
power tool; allow the battery
and power tool to cool down.
Remove the adapter and refit
it again.
Disconnect battery from power
tool , take it off your back,
observe battery and contact
your CRAMER servicing dealer
immediately. If the battery
emits fumes, heats up, smells,
makes noises or shows signs
of deformation, disconnect
it from the power tool, take
it off your back, put it down
and immediately move a safe
distance away. Keep children
and animals away from the
work area. Keep battery away
from combustible materials.
PROBLEM POSSIBLE CAUSE
Battery not fully
charged.
Running time
Useful life of
is too short.
battery has
been reached or
exceeded.
LED indicates
(E0, E1, E2,
E3, E4, E5, Malfunction in
E6)& beep battery.
once per 2
sec.
LED indicates
LO & beep Battery has low
once per 10 charge.
sec.
SOLUTION
Charge the battery.
Have battery checked and
replaced by CRAMER servicing
dealer.
Disconnect battery from power
tool, take it off your back,
observe battery and contact
your CRAMER servicing dealer
immediately.If the battery
emits fumes, heats up, smells,
makes noises or shows signs
of deformation, disconnect
it from the power tool, take
it off your back, put it down
and immediately move a safe
distance away. Keep children
and animals away from the
work area. Keep battery away
from combustible materials.
Charge the battery.
11
cramer.eu
EN