Cramer 82VH860 Manual Del Usuario página 14

EN
PROBLEM POSSIBLE CAUSE
Adapter jams
when being
inserted in Guides dirty.
power tool /
charger.
Battery is
not being Battery too hot
charged even / too cold (LED
though LED on indicate HI or LO &
charger blinks beep continuously).
green.
No electrical
LED on
contact between
charger
charger and
flashes red.
battery.
12
cramer.eu
SOLUTION
Carefully clean the guides.
Allow battery to cool down
to temperatures of about
10-40°C (50-104°F). Allow
battery to warm up slowly.
Operate charger only in
closed, dry rooms at ambient
temperatures of 10-40°C (50-
104°F).
Remove the adapter and refit
it again.
PROBLEM POSSIBLE CAUSE
Malfunction in
battery (the status
LED blinks RED).
LED on
Malfunction in
charger
charger.
flashes red.
SOLUTION
When the battery is inserted
into the charger and the status
LED blinks RED, remove the
battery from the charger for
1 minute, then reinsert. If the
status LED blinks GREEN,
then the battery is properly
charging. If the status LED is
still blinking RED, remove the
battery and unplug the charger
for 1 minute. After 1 minute,
plug in the charger and reinsert
the battery. If the status LED
blinks GREEN, then the battery
is properly charging. If the
status LED is still blinking RED,
the battery is defective and
needs to be replaced.
Check the current at the power
outlet with another tool. Make
sure that the outlet is not
turned off.