Stiga Play The Best T8722 Manual Del Propietário página 3

4. Lay one RH 4 Piece Top Section (#1) and one
LH 4 Piece Top Section (#2) painted side
down on a smooth flat surface with end stripes
aligned. Butt the two center edges against
each other. See Figure 3. Be careful not to
damage the playing surface of your table. We
suggest laying your tops on carpet or some
other similar surface. It is very important that
the surface you are working on is flat. If it isn't,
the top sections may not line up properly.
CAUTION: DO NOT MOVE TABLE TOP HALF SECTIONS UNTIL AFTER THE CONNECTING END RAIL ASSEMBLY, END
RAIL AND TIE PLATES ARE INSTALLED FOLLOWING STEPS 5 - 7! MOVING TABLE TOP SECTIONS BEFORE THESE
PARTS ARE INSTALLED COULD RESULT IN IRREPARABLE DAMAGE TO YOUR TABLE TOP .
CAUTION: DO NOT PUT YOUR ENTIRE WEIGHT ON TABLE TOP BOARDS
WHEN ASSEMBLING TOP . YOU COULD DAMAGE BOARDS.
CAUTION: When screwing screws into wood tops in steps
5-11, tighten screws snug but do not overtighten causing
screws to strip. We do not recommend using a power
driver to attach screws. If you choose to use one, be
extremely careful not to strip screws in the wood.
RIGHT HINGE
5. Lay one of the Connecting End Rails (#6) that you
attached Mounting Brackets (#7) and Casters (#9) to,
on end of top sections without stripes as shown in Figure 4.
Align holes in Mounting Brackets (#7) with pilot indentions in
table top sections. Attach to top with 4 screws (#14) in each of
the 5 Mounting Brackets (#7). See Figure 4.
6. Lay End Rail (#5) on end of top with stripes, align holes in rail with pilot
indentions in table top sections. Attach to top with 7 screws (#14). See Figure 4.
7. Lay two Tie Plates (#10) on center of tops as shown in Figure 4. Align holes in Tie
Plates (#10) with pilot indentions in top and attach with 4 screws (#14) in each plate.
2
14
10
Pilot Indentions
LEFT HAND SIDE
5
14
14
10
14
9
7
3
Figure 3
RIGHT HAND SIDE
END OF TABLE -
NO STRIPE ON THIS END.
LEFT HINGE
6
This end is the middle of the table
and will not have stripe.
Figure 4
1
7
9