Stiga Play The Best T8722 Manual Del Propietário página 4

8. Attach RH Side Rail (#3) to top as shown in Figure 5. Align holes in Rail with pilot
indentions in top and attach with 6 screws (#14).
9. Attach LH Side Rail (#4) to top as shown in Figure 5. Align holes in Rail
with pilot indentions in top and attach with 6 screws (#14).
10. Attach Corner Protectors (#11) to tops as shown in Figure 5. Attach
each Corner Protector (#11) with 1 screw (#14).
14
11
STIGA LOGO
ON THIS END
Figure 5
11. Make two RH and two LH Leg Assemblies by attaching Hinges to Legs exactly as shown in Figure 6. IMPORTANT:
RH Hinge (#12) has a small letter "R" stamped on it and LH Hinge (#13) has a small letter "L" on
it. Hinges must be attached to legs exactly as shown in Figure 6 or legs will not open or close.
A.
To make LH Leg assembly, attach LH Hinge (#13) to outside of Leg (#8) as shown in Figure 6. Attach each
Hinge with Screw (#21), Washer (#23) and Locknut (#22). Tighten snug but do not over tighten. Hinge must
pivot. NOTE: Hinge must operate in direction shown.
B. Make another LH Leg Assembly by attaching Hinge to another Leg the same way you just did in step 11A.
C. To make RH Leg assembly, attach one RH Hinge (#12) to outside of Leg (#8) as shown in Figure 6. Attach
each Hinge with Screw (#21), Washer (#23) and Locknut (#22). Tighten snug, but do not over tighten. Hinge
must pivot. NOTE: Hinge must operate in direction shown.
D. Make another RH Leg Assembly by attaching Hinge to another Leg the same way you just did in step 11C.
Left Hand
Hinge
Figure 6
4
LEFT HAND SIDE
13
21
23 22
Left Hand Leg
Assembly
12
8
4
14
11
14
STIGA LOGO
ON THIS END
Right Hand
Hinge
23
21
22
Right Hand
Leg Assembly
8
RIGHT HAND SIDE
3