Fan Assembly. Pgs - Craftmade Dalton DAL48 A Guía De Instalación Para El Usuario

5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop pin.
Then slide hanging ball off downrod. [Refer to
diagram 1.]
Loosen yoke set screws and nut at top of motor
housing. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod. [Refer to diagram 2.]
Determine the length of downrod you wish to
use. Thread electrical wires through threaded end
of downrod and pull extra wire slack from the
upper end of the downrod. [Refer to diagram 2.]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align
with holes in yoke--make sure wires do not
get twisted. Re-insert pin and clip that were
previously removed. Tighten yoke set screws
and nut securely. [Refer to diagram 2.]
Slide yoke cover and canopy over downrod. [Refer
to diagram 3.]
Thread safety cable and wires through hanging
ball; then, slide hanging ball over downrod--the
top of the downrod should be noted as having a
set screw hole; use this hole when setting the set
screw. Insert stop pin into top of downrod and
raise hanging ball. Be sure stop pin aligns with
slots on the inside of the hanging ball. Tighten
set screw securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw (on
hanging ball) completely could result in the
fan becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
clip
diagram 1
electrical wiring
downrod
clip
diagram 2
electrical wiring
canopy
yoke cover
diagram 3
stop pin
diagram 4
page 5
stop pin
hanging ball
pin
safety cable
yoke set screw
and nut
pin
motor
housing
downrod
motor
housing
set screw hole
hanging ball
canopy