Light Kit Assembly. Pgs; Testing Your Fan - Craftmade Dalton DAL48 A Guía De Instalación Para El Usuario

9. Light Kit Assembly.
Align grooves on glass shade with nodules
on inside edge of LED light kit and push up
gently on glass shade. Twist glass shade to
the RIGHT (clockwise) until glass shade
locks into place.
Pull down VERY GENTLY on glass shade to
make sure that glass shade is secure.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with the pull chain on the switch housing. Start at
the OFF position (no blade movement). First pull
will set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth
pull will again set the fan to the OFF setting. Test
light with the pull chain in the middle. (diagram 1)
If fan and/or light do (does) not function, please
refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extension(s) supplied or custom
pull chain extension(s) (sold separately) to end(s)
of the pull chain(s).
LED light kit
glass
shade
pull chain
for light
diagram 1
diagram 2
page 8
nodules
grooves
reverse
switch
pull chain
for fan
diagram 3 diagram 4