Safety instructions
Electrical cables
!
CAUTION!
• Lay the cables so that they cannot be tripped over or damaged.
• Have damaged power cables replaced by a specialist in accordance
with national regulations.
A
NOTICE!
• If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or bushings to prevent damage.
• Do not lay cables which are loose or bent next to electrically conduc-
tive material (metal).
• Do not pull on the cables.
• Do not lay the AC cable and the DC cable in the same duct.
• Fasten the cables securely.
2.3
Operating the product safely
!
WARNING!
• Operate the product only if you are certain that the casing and the
cables are undamaged.
• Always disconnect the power supply when working on the product.
A
NOTICE!
• Make sure the ventilation grilles in the product are not covered.
• Ensure good ventilation.
2.4
Operating the battery charger safely
D
DANGER!
• The battery may emit explosive gases during the charging process.
Ensure that there are no sparks or flames in the vicinity of the battery.
Ensure that the product is sufficiently ventilated.
!
WARNING!
• Wear safety glasses when handling the battery and especially when
connecting and disconnecting the battery.
• In the event of the skin or eyes coming into contact with battery acid,
rinse out the affected areas immediately with lots of water and call a
doctor.
8
All manuals and user guides at all-guides.com
SMP301-07
EN