Commissioning - Be Cool BC5AC2001FTL Manual De Instrucciones

BEFORE USING THE APPLIANCE FOR THE FIRST TIME
Unpacking the Appliance
1. Open the carton and take out the appliance.
2. Remove all packaging from the appliance.
3. Unwind the mains cable completely and make sure not to damage it.
Transport wheels
For easier transport, the appliance is equipped with transport wheels.
In addition, two rollers are equipped with a locking brake to guarantee that they remain firmly
in position.
1. After the appliance has been carefully unpacked, insert the transport
rollers into the designated notches on the bottom of the appliance.
2. To adjust the locking brakes, press the levers as follows:
PRESS DOWNWARDS  to fix the brake
PUSH UPWARDS to release the brake
INSTALLATION
Please note the following points for installation.
1. Place the appliance on a level and solid surface and adjust the locking brakes so that
the appliance stands firmly in position.
2. There must be at least a 50 cm gap to walls or other objects.
3. Before using the appliance, make sure that both the air inlet and the air outlet are free
of obstacles and are not blocked.
4. Connect the appliance to an earthed outlet.
As soon as you connect the device to the mains, the AirCooler automatically carries out a
diagnostic test to ensure that it is ready for operation. The lights on the front of the unit will
FILLING THE WATER TANK
Open the cover at the top of the appliance and pour water
into it:
Always observe the MIN and MAX markings when filling
the water:
 MIN mark  The water tank must be filled to above
the MIN mark so that the pump can function properly
 MAX mark  The water tank must not be filled over
the MAX mark, otherwise water could enter the inside
of the appliance and thus damage electronic parts.
Close the cover again.

COMMISSIONING

NOTE
blink while this test is running.
Seite 19 von 134
Water