Corsair HYDRO X Serie Manual De Instrucciones página 4

MOUNTING THE XD7 RGB TO A CASE FRONT FAN TRAY
Secure the XD7 RGB (A) onto the case front fan tray.
Use the enclosed M4 x 8mm screws (E).
XD7 RGB MOUNTING ORIENTATION
It is mandatory to install XD7 RGB vertically with pump on the bottom side as shown on the picture. Use
of other horizontal orientation is highly discouraged as it may result in recirculation of air and subsequent
pump failure.
E
A
3
FINALIZING THE SETUP
For combined CPU & GPU water cooling please follow these
recommended installation steps and port configuration:
1. Locate the correct ports. It is mandatory to use the correct
ports, as marked on the picture (see Figure 1).
2. Install the six (6) appropriate CORSAIR XF G1/4 BSPP
threaded-type fittings (not included) into the appropriate distro
plate ports and tighten them by hand as shown in Figure 2. Do
not use any tools (i.e. pliers).
3. Close the remaining open (unused) ports with the included
CORSAIR G1/4 plugs (C) and tighten them using a Plug
Tool (F). Refrain from using a screwdriver as it may result in
damage to the surface of the plugs!
Note: The bottom most two G1/4 ports shall only be used as
drain ports!
Figure 1
CPU OUTLET
CPU INLET
GPU OUTLET
GPU INLET
Figure 2
RADIATOR
INLET
RADIATOR
C
OUTLET
F
4
ENGLISH