Declaration Of Conformity - Parker AC10 Serie Manual Del Producto

DECLARATION OF CONFORMITY

AC10 S
ERIES
MANUFACTURERS EC DECLARATIONS OF CONFORMITY
EMC Directive
In accordance with the EC Directive
2014/30/EU
We Parker Hannifin Manufacturing Limited, address
as below, declare under our sole responsibility that the
above Electronic Products when installed and operated
with reference to the instructions in the Product
Manual (provided with each piece of equipment) is in
accordance with the relevant clauses from the following
standards:- EN 61800-3 (2004)(+A1:2012)
Note: Filtered versions
MANUFACTURERS DECLARATIONS OF CONFORMITY
EMC Declaration
We Parker Hannifin Manufacturing Limited, address
as below, declare under our sole responsibility that the
above Electronic Products when installed and operated
with reference to the instructions in the Product
Manual (provided with each piece of equipment) is in
accordance with the
following standards:-
BSEN61800-3 (2004)(+A1:2012)
Notes:
Non-filtered versions
This is provided to aid justification for EMC
Compliance when the unit is used as a component.
Parker Hannifin Manufacturing Limited, Automation Group, Electromechanical Drives Business Unit,
NEW COURTWICK LANE, LITTLEHAMPTON, WEST SUSSEX BN17 7RZ
TELEPHONE: +44 (0) 1903 737000,
Registered Number 4806503 England. Registered Office: 55 Maylands Avenue, Hemel Hempstead, Herts HP2 4SJ
V S
ARIABLE PEED
relevant clauses from the
(Drives Engineering & Global EM Compliance Manager)
Cumplimiento normativo
D
RIVES
Date CE marked first applied: 01/12/13
Low Voltage Directive
In accordance with the EC
Directive
2014/35/EU
We Parker Hannifin Manufacturing Limited,
address as below, declare under our sole
responsibility that the above Electronic Products
when installed and operated with reference to
the instructions in the Product Manual
(provided with each piece of equipment), is in
accordance with the following standard :-
EN 61800-5-1 (2007)
Low Voltage and Machinery Directives
The above Electronic Products are components
to be incorporated into machinery and may not
be operated alone.
The complete machinery or installation
using this
equipment may only be put into service when
all safety considerations of the Directive
2006/42/EC are fully implemented.
Particular reference should be made to
EN60204-1 2006 (Safety of Machinery -
Electrical Equipment of Machines).
All instructions, warnings and safety
information of the
Product Manual must be
implemented.
Dr. Martin Payn
FAX: +44 (0)1903 737100
14-11
Inversor AC10