HoMedics EnviraScape Manual De Instrucciones E Información De Garantía página 3

Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is controlled by the switch
located at the front of the pump. The speed is indicated by a plus (+) and minus (-)
sign. To increase the speed, move the switch slowly in the direction of the plus sign.
You will hear a click as the switch moves to each speed level. At its highest speed
level, the switch will cease to move any further. To decrease the pump speed, move
the switch toward the minus sign. Similarly, at its lowest speed, the switch will cease
to move any further. NOTE: It is recommended the pump be set at its highest speed
during assembly and later adjusted to a lower setting if desired. Be sure to unplug the
pump before adjusting the speed setting.
3. Lead the cord through the cord slot between the base and the platform. Ensure the
platform is set level on the base. This will ensure that the unit is balanced when placed
on a flat surface. Attach the A/C adaptor jack to the base power cord. DO NOT plug
into outlet at this time (Fig. 1).
4. Insert the tube on the bottom side of the fountain into the pump (Fig. 2).
5. Set the fountain top onto the platform so it sits level.
6. Fill base with tap water to 1/2" from top. We recommend using distilled water to
prevent mineral build up (Fig. 3).
7. Plug the cord into 120V household outlet. The fountain is controlled by the switch
located on the power cord. If pump doesn't operate, rotate in-line switch once to turn
"on" and once more to turn "off". Monthly maintenance will add to your pump's life.
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a 'Drip
Loop' (Fig.4). This will prevent water from running down the cord into the electrical
outlet.
Figure 1
Lights
Fountain Top
Platform
Pump
Base
Tube
ON/OFF
Adaptor
Switch
Cord Slot
4
Maintenance
Caution: • To keep water clean:
All servicing of
Periodically change water and clean the product according to the
this fountain must
water condition. Keeping the water clean prevents the water from
be performed by becoming sticky and forming micro-organisms. We recommend
distilled water to prevent mineral build-up.
authorized
• To clean off hard water deposits on the base:
HoMedics
service Clean the container in a mixture of vinegar and water to clean and
remove any mineral build-up.
personnel only.
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level and to
avoid shortening the life of the pump. NOTE: Never let the pump run
dry.
• Fountain Storage
Unplug the fountain from the electrical outlet, empty the water,
and store in a dry, cool place.
Troubleshooting
Attention:
In order to get
• If the pump fails to operate, check the following:
best results,
Check the circuit breaker, or try a different outlet to make sure the
please operate
pump is getting electrical power. NOTE: Always disconnect from
pump completely
electrical outlet before handling the pump.
submerged
• If the pump gurgles, spews, or "burps":
Check the water level to make sure the pump has
enough water to function.
• Obtaining a desired water level:
Check the water level daily the first week to measure the
rate of evaporation; refill with water as needed.
• If water is splashing outside the fountain:
Adjust the flow control valve to a lower setting on the pump.
Figure 2
Insert tube
into pump
Figure 3
Fill with water
1/2" from top
5