Product Structure; Assembling Instructions; Pipe Connections - Saivod TMS307 Instrucciones De Montaje

PRODUCT STRUCTURE

ASSEMBLING INSTRUCTIONS

 This electric water heater should be mounted on the solid cement walls.
Furthermore, the places where are close to the power source's sockets and conveniently use the water.
Cautions: Please try to use our company's fitted accessories to mount this electric water heater.
After confirming the brackets to be firmly fixed for the reliabilities, then you can hang on this electric
water heater. Otherwise, the electric water heater may fall down from the walls, and cause the severe
damaging accidents.
 Before determining the bolt hole's position, you should
guarantee the right side of the electric water heater
to be more than 200mm away the ground. This will be
convenient to leave out a certain space to maintain when
it is necessary.
 Assembling Method: After selecting the proper positions
well, use the fitted inflation bolt to fix the hanging board
firmly, and then hang on the electric water heater(
Diagram 5).

PIPE CONNECTIONS

 All the pipe parts are G1/2". Wind a certain raw material tape at the water-entering mouth sector
of the electric water heater (Blue Sign Identification) Then re-install the mono-directional security
valve well.
 The remaining pipe's connection method can be referred to No. 7 figure (Diagram 6).
 If the user want to offer the water by poly-routes, then you can refer to the No.8 figure for connecting
the pipes (Diagram 7).
water heater.indd 31
Diagram 3
GB
31
3/1/2017 4:42:43 PM