Electrical Connection; Before Operating The Device - Faro Linda Istrucciones De Uso

High voltage symbol
Do not open or tamper with the device. Live electrical parts inside the
device.

Electrical connection

Before connecting the plug of the device to the power outlet, check that the voltage indicated on the
nameplate corresponds to the voltage of your workplace. (See Fig. 2-1).
The earthing of the device is compulsory according to law. It is prohibited any intentional
interruption of the earthing conductor inside or outside the device or the removal of the earth
pin from the plug, as it makes the use of the device dangerous.
The manufacturer assumes no liability towards people or property resulting from failure to observe
this rule. The electrical safety of this device is ensured only when it is properly connected to an
effective earthing system, as required by the electrical safety regulations in force.
If you do not have an electrical system with regular earthing, do not connect the device to the power
outlet and consult a qualified electrician as soon as possible.

Before operating the device

Before switching on the device fill the steel tank with water or cleaning fluid up to a maximum level
of 3 cm from the top.
Fill the tank only if the power is disconnected. Accidental spillage of liquid may cause a short-circuit
or electrocution and therefore be dangerous for
Make sure that the device is not damaged. Do not use damaged devices; if in doubt, ask your
retailer or the manufacturer directly.
Install the ultrasonic cleaner on a flat and stable surface, able to support the weight of the device,
utensils or objects that are inserted for the washing and the liquid. Handle it with care.
Install the ultrasonic washing machine away from heat sources. In addition, be careful not to
install it near sources of moisture, wet work surfaces, or near sources of dust.
Make sure that the washing machine's feet are in the correct position to ensure air circulation.
Do not use the ultrasonic washing machine if: the power cord or plug is damaged, does not work
properly, has been damaged, or has fallen. This may lead to electrical shock, fire or other accidents.
Do not attempt to personally service the device. Contact only qualified technical personnel or the
manufacturer.
Do not immerse the power cord or the plug in water. Keep the power cord away from hot surfaces.
Do not let the cord hang over the edges of tables or furniture.
Do not leave or do not use this device outdoors.
Do not tamper for any reason the electronic system of the ultrasonic washing machine "Electric
shock hazard". For any repairs, always contact the manufacturer's technical service department.
Do not replace the power cord. If the cable is damaged due to
Istruzioni d'uso / Instructions for use / Mode d'emploi / Gebrauchsanleitung / Istrucciones de uso
LINDA Ultrasonic Cleaner / Vasca Ultrasuoni – Rev.00
WARNING
THIS DEVICE REQUIRES EARTHING.
the operator.
C 2
HAPTER
13