Heating Operation (This Function Is Not Available For A Cold-Single Unit); Timer Operation; Speed Function; C/°F Function - Beko BP207C Manual De Usuario

7. Operation introduction
7.5 Heating operation (this function
is not available for a cold-single
unit)
– Press the "Mode" button till the "Heat" icon
appears.
– Press the "∧"or" ∨" button to select a
desired room temperature. (16°C-31°C)
– Press the "Fan Speed" button to select
wind speed.

7.6 Timer operation

Timer On setting:
– When the air-conditioner is Off, press the
"Timer" button and select a desired ON
time through the temperature and time
setting buttons.
– "Preset On Time" is displayed on the
operation panel.
– On time can be regulated at any time in
1-24 hours.
Timer Off setting
– When the air-conditioner On, press "Timer"
button and select a desired Off time through
the temperature and time setting buttons.
– "Preset Off Time" is displayed on the
operation panel.
– Off time can be regulated at any time in
1-24 hours.

7.7 Speed function

Press the "Fan Speed" button to select wind
speed.(high speed/low speed).
7.8 °C/°F function
press the °C/°F button to switch between Celsius
and Fahrenheit temperature displays.
(adjustment range: 16-31°C / 61-88°F).
26 / EN

7.9 Water dainage

Water full alarm function
The inner water tray in the air-conditioner
has one water level safety switches, it
controls the water level. When water level
reaches an anticipated height, the water
full indicator lights up. When the water is
full, please remove the rubber blockage
from the drainage hole at the bottom of
unit, and drain all water outside.
Continuous drainage
– When you plan to leave this unit unused
for a long time, please remove the rubber
blockage from the drainage hole at the
bottom of unit, and drain all water outside.
– You shall use the continuous drainage with
a drainage hose connected to the bottom
drain hole, when the unit working at the
Heat or Dehumidify mode.
– The continuous drainage does not need
to be applied when the unit working at
the Cool mode. The unit can evaporate the
condensate water automatically by the
splash motor. Make sure the drainage holes
are stemmed well.
– If water splash motor is damaged,
continuous drainage can be used. To
connect the drain hose to the bottom drain
hole (Fig.6), the unit can also work well.
– If splash motor is damaged, intermittent
drainage can also be used. Under this
condition, when the water full indicator
lights up, please connect a drain hose to
the bottom drainage hole, then all the
water in the water tank will be drained
outside. The unit can also work well.
Local air-conditioner / User Manual