FAR BSF R&B CI Manual Del Usuario página 17

ENGLISH
• After the kettle has switched off automatically
(or you switch it off manually), it needs time to
cool down. After 15-20 seconds, the kettle can
be switched on again.
• Always fill the kettle with water before
switching it on.
• The kettle is designed to cut the heating
element off from the power supply in the case
of a malfunction/abnormal situation. If the
kettle is accidentally switched on while it
doesn't contain water, the anti-boil-dry safety
system will be triggered.
• If the kettle heats while dry, the power-on
indicator will switch off. Wait 15 minutes to
allow the kettle to cool. The thermal circuit-
breaker will automatically reset during this
time. Remove the kettle from the base, then
refill with cold water. The appliance will work
again.
• Place the kettle on a stable, flat surface.
• Do not use this appliance outside.
GB-6
• Ensure that the kettle is switched off before
removing it from the base.
• Do not remove the kettle from the base while
it is switched on.
• Do not immerse the kettle or its power cord
in water or any other liquid. Ensure that no
liquid penetrates the electric parts of the kettle.
• Prevent children from pulling the power cord
or tipping the kettle upside down.
• Ensure that the power cord does not hang
from the work surface.
• The external surfaces of the kettle may become
burning hot when in use. Pay attention when
using the kettle.
• Never fill the kettle with water above the
maximum acceptable level.
• Never use the kettle with the lid open.
• Do not open the lid while steam is escaping
from the spout.
• Before cleaning the kettle, unplug it from
the power socket and wait until it has cooled
completely.
ENGLISH
GB-7