Technical Data; Cleaning And Maintenance - Royal Catering RCWM-1400-B Manual De Instrucciones

The operation manual must be reviewed.
Never dispose of electrical equipment together
with household waste.
This machine conforms to the CE declarations.
For indoor use only.
Attention! Hot surface may cause burns.
PLEASE NOTE! Drawings in this manual are for
illustration purposes only and in some details it may
differ from the actual machine.
The original operation manual is in German. Other
language versions are translations from German.
USER MANUAL
SAFETY INSTRUCTIONS
General safety information for the use of electrical devices
To avoid injury from fire or electric shock, please ensure
the compliance with the safety instructions when using this
device. Please read the instructions carefully and make sure
that you have understood them well. Keep the manual near
the equipment to be able to read it at any time. Always use
current sources which are connected to the ground and
which provide the necessary voltage (this info is indicated
on the label on the device). If you have any doubts, let an
electrician check that your outlet is properly grounded.
Never use a damaged power cable. Do not open the unit
in damp or wet environment, or if your hands or body are
damped or wet. Protect the unit from solar radiation. Use
the device in a protected location to avoid damaging the
equipment or endangering others. Make sure the device is
able to cool and avoid placing it too close to other devices
that produce heat. Before cleaning the device, disconnect it
from the power source. Use a soft damp cloth for cleaning.
Avoid using detergents and make sure that no liquid enters
the unit. No internal element of this device needs to be
maintained by the user. Opening the device without our
approval leads to a loss of warranty!
SAFETY GUIDELINES
1. Please read and understand these instructions
carefully before operating the device! Please observe
the safety guidelines carefully in order to prevent
damages through improper use!
2. Please keep this manual available for future
reference. If this device is passed on to third parties,
the manual must be passed on with it.
3. Only use this device indoors and for its intended use.
4. We do not offer any warranty for damages resulting
from improper use or incorrect operation.
5. Before the first use, check whether the main voltage
type and current comply with the indicated data on
the type plate.
6. This device is not intended to be used by persons
(including children) with limited physical, sensory or
mental aptitude, as well as lack of experience and/or
knowledge, unless they are supervised by a person
responsible for their safety or if they have received
instructions as to how the device is used.
7. ELECTRIC SHOCK HAZARD! Do not attempt to repair
the unit yourself. In case of device failures, repairs
must be done by qualified experts.
6
U S E R M A N U A L
8. Please check the main plug and the power cable
regularly. If the power cable for this device is
damaged, it has to be replaced by the manufacturer
or its customer service or another qualified person in
order to prevent hazards.
9. Prevent damages to the power cable by avoiding
squeezing or bending it or rubbing it on sharp
edges. Also keep the power cable away from hot
surfaces and open flames.
10. ATTENTION! DANGER TO LIFE! While cleaning, never
immerse the device in water or other liquids.
11. Under no circumstances should the housing be
opened.
12. When using the device, never touch the heating
plate or its enclosure, as they constitute a scalding
hazard. When opening hot device, remember that
steam will be released.
13. Place the device away from flammable materials and
at least 20 cm from walls, windows, etc.

TECHNICAL DATA

Product name BUBBLE WAFFLE MAKER
Model RCWM-1400-B
Rated voltage [V] 230~
Frequency [Hz] 50
Rated power [W] 1415
Temperature range [°C] 50 – 250
Heating surface 175x205
dimensions [mm]
Weight [kg] 5,3
SCOPE OF APPLICATION
The Egg Bubble Waffle Maker is designed for making bubble
waffles.
The user is liable for any damage resulting from nonintended
use of the device..
BEFORE THE FIRST USE
Upon receipt of the goods, check the packaging for integrity
and open it. If the packaging is damaged, please contact
your transport company and distributor within 3 days, and
document the damages as detailed as possible. Do not turn
the package upside down! When transporting the package,
please ensure that it is kept horizontal and stable.
DISPOSAL OF THE PACKAGING
Please keep all packaging materials (cardboard, plastic tapes
and Styrofoam), so that in case of a problem, the device can
be sent back to the service centre in accurate condition!
INSTALLING THE APPLIANCE
APPLIANCE LOCATION
The temperature of the environment must not exceed 45°C
and the relative humidity should not exceed 85%. Ensure
good ventilation in the room in which the device is used.
The distance between the back of the chain toaster and the
wall should be at least 20 cm, a minimum distance between
the sides of the device and the walls should be at least 10
cm on each side and 35 cm between the top of the device
and the ceiling.
Rev. 16.11.2017
Keep the device away from hot surfaces. Operate the device
on flat, stable, clean, refractory and dry surfaces out of the
reach of children and people with mental disabilities. Install
the device making sure that constant access to the main
plug is ensured. The power cord connected to the appliance
must be properly grounded and correspond to the technical
details. Before the first use, remove all elements and clean
them along with the entire device!
PRINCIPLE OF OPERATION
3
2
1
4
8
7
6
5
1. handle
2. top heating surface
3. twist attachment
4. bottom heating surface
5. timer
6. thermostat
7. ON/OFF switch
8. thermostat light
Before using the device, make sure the thermostat knob is set
to "0". Switch the device on – the switch will be illuminated
in red, set the thermostat to the required temperature – the
thermostat light will come on. Once the heating surfaces
reach the required temperature the thermostat light will
turn off. Use handle to carefully open the top lid, (grease
the heating surfaces if required), pour an appropriate
quantity of batter (prepared earlier) into the bottom heating
surface, close the device and distribute the batter over
the heating surfaces by turning the handle clockwise. The
heating surfaces may be rotated by up to 180°. To remove
ready waffles, align the heating surfaces in their original
positions and carefully open the top lid (caution: hot). When
removing waffles be careful so as not to damage the heating
surfaces. The device features a timer which can be set to
emit a characteristic noise after a certain time has elapsed.
To make further waffles, proceed analogously to the steps
described above, keeping an eye on the time. After use, set
the thermostat to "0" and switch the device off suing the
ON / OFF switch. Once the device has cooled down, clean
it thoroughly.
ATTENTION! Do not eat the first few waffles.
CAUTION: before the first use, be sure to thoroughly clean
and grease the heating plates, then heat them up without
dough. As the device heats up, the smoke can develop
slowly – which is perfectly normal. You just need to ensure
sufficient ventilation. After a few minutes, turn the device off
and wait for it to cool down, then grease the heating plates
– the device is ready for work.
ATTENTION! It is possible to replace the heating surfaces
(together with handles). Heating surfaces should be replaced
by a workshop or a qualified technician!
Rev. 16.11.2017
Assembling the device handles:
Attach handles onto the device before use. See photograph
below:
TRANSPORTATION AND STORAGE
During transport, the machine should be protected from
shaking, crashing and turning upside down. Store it in
a properly ventilated place with dry air and without any
corrosive gas.

CLEANING AND MAINTENANCE

• Always unplug the device before cleaning the
equipment. Disconnect the device from the electricity
when it is not in use. Let the device cool down before
cleaning it.
• Use only cleaner without corrosive substances to
clean the surface.
• After each cleaning, all the elements must be carefully
dried and secured by greasing the heating plates.
• Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
• Never clean the device with a pressurized water-jet,
industrial cleaners, and brushes or any other type of
cleaning utensil that could damage the surface of the
appliance.
REGULAR CONTROL OF THE DEVICE
Check regularly the device to see if it presents any damages.
If there is any damage, please stop using the device. Please
contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare the
following information:
• Invoice number and serial number (the latter is to be
found on the technical plate on the device).
• If relevant, take a picture of the damaged, broken or
defective part.
• It will be easier for your customer service clerk to
determine the source of the problem if you give
a detailed and precise description of the matter.
Avoid ambiguous formulations like "the device does
not heat", which may mean either that it does not
heat enough or that it does not heat at all. The more
detailed your information, the better the customer
service will be able to solve your problem rapidly and
efficiently!
CAUTION: Never open the device without the authorization
of your customer service. This can lead to a loss of warranty!
7