Installation - Glacier bay 67364W-6A01 Guía De Uso Y Mantenimiento

Installation

1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Remove the preassembled lock nut (H) and
washers (G) from the new faucet (A).
□
Place the faucet (A) through the mounting
holes in the sink.
□
Ensure the slot openings of the washers (G) face
toward to the rear of the sink.
□
Secure the faucet (A) to the sink using the lock
nut (H) provided.
A
2
G
H
A
1
H
2
Installing the faucet handles
NOTE: The hot water valve is identi ed with a label.
□
Remove the preassembled nuts (E) and washers
(D) from the hot and cold faucet handles (B and C).
□
Loosen the screws (F) on the nuts (E) until the
ends of the screws (F) are ush with the face of
the nuts (E).
□
Insert the hot faucet handle (B) to the left of the
spout and cold faucet handle (C) to the right of
the spout.
□
Attach the faucet handles (B and C) underneath
the sink using the washers (D) and nuts (E).
Securely tighten the screws (F) on the nuts (E).
E
2
D
3
E
F
4
F
B
C
2
D
3
E
F
E
F