Safety Recommendations; Warnings For The Installer; Warnings For The User - GGMgastro PEP Manual De Instrucciones

1

SAFETY RECOMMENDATIONS

WARNINGS FOR THE INSTALLER

Check that the location of the oven is in compliance with local, national and
European regulations.

Adhere to the instructions in this manual.

Do not execute electrical connections using temporary or uninsulated cables.

Check that the ground connection of the electrical system is functioning properly.

Always use individual safety devices and other means of protection in compliance with
the law.

REMOVE POLYSTYRENE FROM UNDER THE STONES BEFORE TURNING
THE OVEN
WARNING FOR THE USER
The conditions in the surrounding area where the machine will be installed must have
the following characteristics:

the area must be dry;

the area must have water and heat sources at an adequate distance;

ventilation and lighting must be suitable and comply with the hygiene and safety
standards foreseen by current laws;

the floor must be flat and compact to facilitate thorough cleaning;

there must be no obstacles of any kind in the immediate vicinity of the machine that
could effect the machine's normal ventilation.
In addition, the user must:

make certain to keep children away from the machine when it is operating;

adhere to the instructions in this manual.

not remove or tamper with the safety devices on the machine;

always pay careful attention to the work at hand and not use the machine when in a
distracted state;

perform all operations with maximum safety and calm;

respect the instructions and warnings displayed on the machine labels.
The labels are accident prevention devices, and therefore must always be perfectly legible. If
these should be damaged and illegible, it is mandatory to replace them by requesting
replacements from the Manufacturer.

At the end of each working shift, before cleaning, maintenance or transfer operations,
disconnect electrical power.
WARNINGS FOR THE MAINTENANCE OPERATOR
Observe the instructions indicated in this manual.

Always use individual safety devices and other protection means.

Before starting any maintenance operations, make sure that the oven, it was used, is
cooled down .

If any of the safety devices is worn or faulty, the oven is also considered faulty and not
to be used.

Disconnect electrical power before intervening on electrical or electronic parts and
connectors.
- 22 -