Collomix CMG 2600 Manual De Servicio Original página 13

for any reason. This will prevent any sudden run-
Do not use the machine if any part of the housing
switch, power line or plug.
grinding disk is equal to or higher than the mo-
tor speed of the machine. Only use appropriate
accessory parts.
The exterior diameter of the grinding cup must
match the measurements provided on the power
tool.
onto the grinding spindle of your power tool.
Diamond cup disks must only be used for their
The device may only be operated with the protec-
Only use cup wheels which are smaller than the
Replace the lamellar ring when it is worn.
chine before use and comply with the
chine.
The use of a face mask is recommended
for dust-intensive tasks.
Assembly
Disconnect the mains plug from the wall plug
before carrying out any tasks on the device.
Adjusting the handle
Open the two wing nuts left and right and move the
handle to the desired position. Tighten the wing nuts
again.
Mounting the diamond grinding disk:
Select a diamond grinding disk that matches the grade
Only use diamond grinding disks that comply with the
data listed in the table below.
hole in the diamond cup wheel.
The permissible rotational speed of the diamond
grinding disk used must at least match with the data
listed in the following table.
Please note the data provided on the diamond grind-
ing disk regarding its rotational and circumferential
speed.
max D
-
180 22.2
spindle using the socket spanner provided. While
-
dle to stabilise the cup wheel. When working with
the suitable Collomix diamond cup wheel, always
nut and spacer disk.
(10) on the threaded spindle. Press and hold the
spindle from turning.
running before switching on the machine. The
disk must not come into contact with the protec-
The cup wheel can heat up during use. Leave to cool.
You could burn your hands or cut/ tear your skin on
when changing tool inserts.
material load. Interrupt your work immediately if you
Only use original accessory parts!
Rev. 3 / 13
d speed [min
-1
8500
max. height
80 30
-
-