de dispositifs, à la seule condition que la somme d'indicesd'équivalence de la
sonnerie de tous les dispositifs n'excède pas 5.
FCC REQUIREMENTS
This equipment complies with Part 68 of the FCC rules and the requirements
adopted by the ACTA. On the bass unit of this equipment is a label that
contains, among other information, a product identifier in the format US:
ASUDL01BDSLN1U. If requested, this number must be provided to the telephone
company.
The REN is used to determine the number of devices that may be connected to a
telephone line. Excessive RENs on a telephone line may result in the devices not
ringing in response to an incoming call. In most but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of devices that may be
connected to a line, as determined by the total RENs, contact the local telephone
company. For products approved after July , 001, the REN for this product is
part of the product identifier that has the format US: ASUDL01BDSLN12U. The
digits represented by 01 are the REN without a decimal point (e.g., 0 is a REN of
0.). For earlier products, the REN is separately shown on the label.
If your equipment causes harm to the telephone network, the telephone company
may discontinue your service temporarily. If possible, they will notify you in
advance. But if advance notice is not practical, you will be notified as soon as
possible. You will be informed of your right to file a complaint with the FCC. Your
telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the proper functioning of your equipment. If they do,
you will be notified in advance to give you an opportunity to maintain uninterrupted
telephone service.
If you experience trouble with this telephone equipment, please contact the
following address and phone number for information on obtaining service or
repairs. The telephone company may ask that you disconnect this equipment from
the network until the problem has been corrected or until you are sure that the
equipment is not malfunctioning. This equipment may not be used on coin service
provided by the telephone company. Connection to party lines is subject to state
tariffs.
Company: ASUS Computer International
Address: 800 Corporate Way, Fremont, California 9459, USA
Tel no.: +1-510-9-
A plug and jack used to connect this equipment to the premises wiring and
telephone network must comply with the applicable FCC Part 68 rules and
requirements adopted by the ACTA. A compliant telephone cord and modular
plug is provided with this product. It is designed to be connected to a compatible
modular jack that is also compliant. See installation instructions for details.
Apéndices
51
DSL-N1U